Furniture verification
Six checks at the bench before the seal is issued.
Furniture arrives at the Myrtle Beach hub before it is listed as certified. A bench inspector works through six checks, in order, and records what is found. Nothing is guessed. If a check cannot be completed, the piece is listed without the seal.
01
Wood species identified
We identify primary and secondary woods by grain, pore structure, color under raking light and weight, with a hand lens where figure is ambiguous. Veneers are noted as veneers, with the substrate named when it can be seen. Species appears on the certificate exactly as identified. Mahogany is not written when the wood is sapele.
- Primary wood and secondary wood
- Solid or veneer, and the substrate
- Grain match across panels and leaves
02
Joinery inspected
Joints tell you how a piece was built and roughly when. We look for hand cut versus machine cut dovetails, mortise and tenon, dowels, pocket screws, staples and glue blocks. Each joint type is recorded, along with whether it is tight, loose or previously reglued.
- Dovetail type and spacing
- Mortise and tenon, dowel or fastener
- Evidence of regluing or replacement
03
Structural soundness
The piece is set on a level floor and loaded. Chairs are sat in, tables are racked by hand, drawers run their full travel, doors close on their catches. Wobble, racking, cracked rails and sprung veneer are measured and written down, not described as minor.
- Rack and wobble under load
- Cracked or repaired rails, stretchers and legs
- Drawer and door travel
04
Finish and surface
We record the finish type, whether shellac, lacquer, oil, wax, paint or a modern polyurethane, and its condition under raking light: crazing, alligatoring, water rings, sun fade and losses. A refinished surface is called refinished.
- Finish type
- Crazing, rings, fade and losses
- Original surface or refinished
05
Measured W x D x H
Width, depth and height are taken with a steel tape at the widest points, including hardware, and recorded to the quarter inch. Seat height and arm height are added for seating, apron clearance for tables, and interior drawer dimensions for case goods. These are the numbers you see in the dimensions block on every listing.
- Width, depth and height at the widest points
- Seat and arm height for seating
- Apron clearance for tables
06
Restorations disclosed
Any repair, replacement or refinish we find is written into the certificate whether or not the seller disclosed it. Replaced hardware, patched veneer, new upholstery, reglued joints and tipped feet are listed plainly. Undisclosed restorations found at the bench are added to the listing before it goes live.
- Replaced hardware or feet
- Patched or replaced veneer
- New upholstery, reglued joints, refinish
The certificate travels with the piece. It is issued by the hub, not by the seller, and the inspector's findings are shown on the listing word for word.